Brookfield Engineering Labs., Inc. Page 25 Manual No. M/94-310F
APPENDIX C - Glossary of Screen Displays
“CAL COMPLETE” - Cone calibration complete
“CALIBRATE? NO” - Toggle to select cone calibration
“CALIBRATE? YES” - Toggle to select cone calibration
“CALIBRATING (00)” - Calibrating cone No. (00)
“CALL FOR SERVICE” - System error is found
“CAP 1000L” - Model No. for CAP 1000L (5°C to 75°C)
“CAP 1000H” - Model No. for CAP 1000H (50°C to 200°C)
“CAP 2000L” - Model No. for CAP 2000L (5°C to 75°C)
“CAP 2000H” - Model No. for CAP 2000H (50°C to 200°C)
“CGS UNITS” - Viscosity and Shear Stress in CGS units (P and dynes/cm
2
)
“EXTERNAL CONTROL” - External control mode (CAP 2000)
“FLUID = 00000 CP” - Fluid viscosity entry for cone calibration
“100% = 0000 P” - Full Scale Viscosity Range (FSR) for cone (00) after set speed entry
“SAMPLE NO. 0000” - Sample No. 0000 entry
“SELECT CONE 00” - Cone No. (00) entry
“SET RPM 0000” - Motor speed entry
“SET RUN TIME 000” - Set timer entry
“SET TEMP 00.0°C” - Temperature entry for CAP 1000L and 2000L
“SET TEMP 000.0°C” - Temperature entry for CAP 1000H and 2000H
“SI UNITS” - Viscosity and Shear Stress in SI units (Pa•s and N/m
2
)
“SMC (00) = 000000” - SMC entry for cone No. (00)
“SR: 00000/SEC” - Shear Rate for cone (00) after set speed entry
“SRC (00) = 00.0000” - SRC entry for cone No. (00)
“TEMP = 000.0°C” - Display current temp. for auto zero and cone calibration
“ 25.0°C” - Main screen
“USE FLUID (00)” - Use cal. fluid for cone No. (00) when auto zeroing
Comments to this Manuals